Homestrand Mariner Kerosene stove - 205-32K

Discussion in 'Other Brands' started by Rai, Nov 3, 2018.

  1. Rai Japan

    Offline
    Joined:
    Oct 12, 2018
    Messages:
    57
    Location:
    Japan,Kanagawa
    Hi @kerophile

    It is very interesting.
    There is no plan to remodel this stove,
    We plan to remodel cookstove that will arrive this month or next month. (For combustion experiment)
    We are planning to use phoebus 625 which I bought as a donor again.
    I would like to test the skirt by all means.

    There are so many things I want to do and I will not go on at all.
     
  2. Aleks-S

    Offline
    Joined:
    Sep 9, 2016
    Messages:
    80
    私が正しく理解しているか分からない。
    キャップの交換が火炎に影響するならば、おそらくこれが問題です。
    両方の場合において、混合物は同じである。
    しかし、そのスピードは小さなギャップ "A"ではそれほどありません。
    空気と燃料はよく混合されません。
    結果として黄色の炎。

    Not sure I understood correctly.
    If the exchange of caps affects the flame, then perhaps this is the issue.
    In both cases, the mixture is the same.
    But its speed is less in a small gap "A".
    Air and fuel are not well mixed.
    Yellow flame as a result.
    snapshot20181105184910.JPG
     
  3. Rai Japan

    Offline
    Joined:
    Oct 12, 2018
    Messages:
    57
    Location:
    Japan,Kanagawa
    Hi @Aleks-S

    It is bedtime but I tried it.
    Good Silent cap + bad inner cap
    · Flame became big
    · Orange increased
    · Small explosion became big
    · It is considerably better than a bad combination.

    Measure silent cap and inner cap with calipers and you can not find a big difference.
    The digital calipers' batteries are gone, so I can not see the details (Presbyopic eye)
    I will try to find some difference.

    IMG_20181106_024532.jpg IMG_20181106_024534.jpg IMG_20181106_024536.jpg
     
  4. Rai Japan

    Offline
    Joined:
    Oct 12, 2018
    Messages:
    57
    Location:
    Japan,Kanagawa
    It is the first test in the morning.
    To confirm the indicated clearance.
    I made a gasket using aluminum foil and lifted the silent cap about 1 mm.
    It is orange like the picture, but the combustion stabilizes.
    Orange may be an aluminum foil coating agent.
    It becomes a gentle flame like a picture. Orange's illegal explosion does not occur.

    @kerophile @Aleks-S @JP2
    Thank you for teaching patiently.
    I would like to test variously and make a favorite flame.

    aaa.jpg
     
  5. Rai Japan

    Offline
    Joined:
    Oct 12, 2018
    Messages:
    57
    Location:
    Japan,Kanagawa
    It was almost a blue fire.

    It was most effective to attach a pipe like this.
    pipe.jpg



    The irregular explosion disappeared, both the large flame and the small flame stabilized.
    big.jpg


    small.jpg



    Phoebus 625 A good flame was made with the silent cap intact.
    Phoebus 625.jpg

    The gap indicated in Aleks-S is influenced by the gas jet speed. (In this test)
    By increasing the gap you can earn vaporization time so it can be a blue fire.
    Increasing the gap creates a gentle flame.
    Fast gas is squirted when decreasing the gap.
    If it decreases too much, the flame will disappear due to the jetting speed and the leaking fuel will only be ignited.

    This time I learned a lot.
    I thank you for leading my bad words, bad knowledge.
    Thank you very much.
     
  6. Tony Press

    Tony Press Australia Subscriber

    Offline
    Joined:
    Jun 8, 2013
    Messages:
    9,296
    Location:
    Stinkpot Bay, Howden, Tasmania, Australia
    Well done, @Rai.

    Cheers

    Tony