Good outcome John and thanks for the effort you put into your projects and presentations. :)
I back @Big Si on this one. We await John's verdict. :)
@Krisse . :-k I wonder about those retaining slots used for securing the outer cap. They may encroach too close to the upper vapour chamber...
@Koolkat . Just put a drop of light oil on that lead washer and it should be good to go. John
Use only kerosene(not white gas or Colman fuel) in that stove or you could end up with a bomb. John
Hello @Quick Cal . That black blob indicates to me that you may have some type of foreign residue in the wick that dissolves as the fuel passes...
Hello @Brad Jackson . The type of rubber hose that you may have on your car carburetor, vacuum hoses etc.... with a small enough inside diameter...
Hey @Doc Mark . That brass washer is supposed to be soldered there where it is. It along with the leather washer in front of it and between the...
Hello @Sternenlicht . I looked at your Primus DRP in your first post about it and can see that it is covered in hardened kerosene shellac runs....
Hello @Cookie . You may have to lightly squeeze the outer cap to clear the raised lug on one side. Try not to over squeeze or you may distort the...
If you can trace the previous owners of the caravan, you might be lucky to find they might still have the parts. Worked for me on a couple of...
Hello Doc. I haven't worked on one of those stoves but I am guessing that the brass nut shouldn't be there under the fuel cap. Could the vent...
Try filling the tank with meths then seal and wipe dry. Make sure you remove the wick first. Alcohol finds its way through cracks, pinholes, also...
There is a possibility that the sealing surface of the brass part that comes into contact with the pip to create the seal, may be etched or have a...
Hello @hikerduane . At a guess, the jet aperture size might be too large. You may require a jet with a smaller aperture to stop the internal...
Hello @monkeyboy . Just make sure you have the pencil torch turned down at it's lowest but having a blue flame still. Then play the flame...
Hello @Steven59 . If you are still having problems, remove and clean out the inside of the burner jet with a rolled up piece of fine grade wet...
Hello @snwcmpr . Looking at it again, I would say you are correct. Cheers, John:)
Hello @burny pyromaniac . That leather piece is the remains of a used leather pump cup. Cheers, John
Same here and for safety reasons only. They can run on either fuel. Having said that; I have had one Campingo that had a typed note that came...
Separate names with a comma.
