New Ebros stove purchase

Discussion in 'Stove Forum' started by MarkG, Aug 14, 2019.

  1. MarkG

    Offline
    Joined:
    Aug 12, 2017
    Messages:
    39
    Hi all,

    I'm still new to stoves so i'm after some advice please, the jet orifice on my new purchase seems rather large and all the prickers i've got are lost in it, although all the generic jets i've bought the Optimus No 330 prickers don't seem to fit so are there different sized jets for different stoves or are they all pretty similar? also i tried to get the stove running earlier after cleaning/checking the NRV etc but the flame only burns in one place, there is probably a 10 - 15 mm gap between the jet and the base of the flame (not sure if i over pressurised it slightly) there is also quite a bit of soot underneath the pan support and last but not least, i can't remove the jet, i can just about get the smaller of my two tools in there but i can't get it to sit completely over the jet and there is no room to turn it, the burner has got the word power criss crossed across it, although not original i may try and get another burner to fit so that the stove works,

    Thanks.