Well, unfortunate happened on an Enders Baby 9063 repair. Heat and Cold Cycle, Soaking and could not get it loose. Little to hard on the turn and snap. Broke it. What are the chances there is a Valve assembly out there still? I'm never getting the broken part out of this
In my 35 years collecting time never see something like this on a stove... much more demaged pipeline to the tank. Do you have a turning mashine? Good luck RJ
I know - I was devistated - I was just getting ready to Nickel Plate the Grill in the meantime and thought It was a possible loss of a great stove. Yes, Pharael has shown me again, the great kinship and hope in this community Yes, this one had some damage and I was going to need to drill the tank pipe - Old wick and wire inside there is like Concrete. Nothing was softenting it up. I dont know, I dont think I was putting that much effort. I didnt even have it in a vise I was holding it so I could feel the tension. No turning machine access. I was looking at how I could incorporate one of my Parts 8R's to accomidate but that was a bust.
Thank you Remus1956, I appreciate the offer of assistance but I have one on the way from another member who was able to part with one as well!!
Enders 9063 Benzin Baby up and running Shout out to Pharael! I also added new gaskets, PIP's, graphite and wick. It was due for some serious TLC. PIP's were rock hard, always good idea to check, replace those. Nickel plating coming up next and be finished with it..
