Here are my notes on how to produce the nipple jet remover for roarer burners on a miniature metal lathe: 1) Mill a round brass staff to 14,7mm...
This is really helpful, Knee, thanks for sharing! I already made my own version today from a piece of left over round brass bar, diameter 14mm....
Some time ago, I chanced upon a post on the CCS website where a different nipple/jet remover tool for roarer burners was shown. It was a solid...
Hello Ben, I recall having seen locally made stoves like the one you present here all over the place in Egypt way back in the 1970s and 1980s....
Hi Keeper-of-the-flame, hope you don't mind my asking for some dimensions for your adaptation of the Tilley vaporizer. Most of all I'm interested...
Thanks, Nicola and Harder, first time I see this and I ordered a small mat of carbon felt rightaway - seeing is believing :-)
Where did you get the pre-heater wick thing from? It looks like a cannibalized pre-heater for a Tilley lamp, at any rate a good idea since it will...
Thanks again, Majic. My lifelong experience with unscrewing bicycle pedals or handlebars from vintage bicycles taught me to go for both - to heat...
Actually I found out that ATF is being sold at €4,70 here in the Netherlands in cans of 250ml (1/4 liter) as transmission oil for mopeds (mostly...
Glad you did some research, Majic! I should have done so myself but then again, I'm not really into car mechanics, maybe you are, so I just...
Thanks again, Harder. I had not paid too much attention to the "ATF mix" suggestion but today found this post (at V8Buick.com) which might...
That works for me. I prefer to have a fluid sealant rather than a tape - where you always have the issue of whether the tape will sit still/remain...
Thanks a lot for these excellent 2 pieces of advice, Nicola! What thread sealant, withstanding which maximum temperature would you recommend? I...
Thanks for that, Harder! I will try your method and will subsequently share my findings. Just still trying to ensure the best way to span the...
Hi Majic (if I may abbreviate), thanks for that diagram. My 725 came with an exploded view as part of the instructions manual and when you look in...
Hi Majic Wrench, I fully agree with that in most instances - if it ain't broke, don't fix it is often the best approach. But the burner being that...
Good day, I wonder whether anyone ever tried to take off the entire burner body from a Phoebus gasoline stove; mine being a 725. Going by the...
Any suggestions on what carburettor cleaner to use for declogging generators/vaporizers? I recall having seen a thread where Halford's was...
Separera namn med ett kommatecken.
