SVEA 123R

Discussion in 'Svea No: 123 & 123R' started by woodsy97845, Aug 18, 2012.

  1. woodsy97845

    Offline
    Joined:
    Jul 13, 2012
    Messages:
    105
    Ex-Fireball.

    Here is a shot of the 123R that caused so much dissension amonst the ranks earlier this week.

    I will wait until this evening when it is a bit darker to take flame shots that actually "show up" The tips are a bit yellow, but I am VERY VERY pleased with how it turned out.

    Thank you everyone for all of your help.

    Cheers,

    Woodsy

    1345306033-123R_opt.jpg

    1345306170-123R_burning_opt.jpg
     
    Last edited by a moderator: Jun 26, 2015
  2. yonadav

    yonadav Subscriber

    Offline
    Joined:
    Mar 3, 2010
    Messages:
    2,366
    Location:
    Israel
    Congratulations!

    Please tell us what you did.

    You can probably eliminate the yellow flame by slightly raising the flame plate - bend its legs a little downwards.

    Enjoy!

    Yonadav
     
  3. woodsy97845

    Offline
    Joined:
    Jul 13, 2012
    Messages:
    105
    First, I removed the cleaning needle, then I replaced the wick...to replace the one that was soaked in kerosene :oops: :oops: Not that I needed to, but it made me feel better.

    I then filled it with Coleman white gas and let it sit for about 30 minutes for the wick to absorb the gas. I primed it with denatured alcohol and lit it; it sputtered then took off. At first it sounded like a Huey (UH-1) but then settled into a steady and pleasant roar.

    When I shut it off after a few minutes, there was a candle flame that remained for about 30 seconds before dying. I have ordered a service kit with new graphite, cleaning needle etc and will clean the valve spindle with emery cloth when that arrives. No need to tear her down more than is needed.

    Cheers,

    Woodsy
     
  4. woodsy97845

    Offline
    Joined:
    Jul 13, 2012
    Messages:
    105
    Here are the flame shots for this stove.

    1345347214-123R_low_opt.jpg

    1345347186-123R_high_opt.jpg

    I tried bending the arms of the flame spreader down just a bit, but it didn't seem to make any difference. I am a tad "gunshy" about doing too much at this point...It's Running. :D/ :D/

    Cheers

    Woodsy
     
    Last edited by a moderator: Jun 26, 2015
  5. Doc Mark

    Doc Mark SotM Winner Subscriber

    Offline
    Joined:
    Dec 12, 2004
    Messages:
    19,661
    Location:
    So. California Mountains
    Hi, Woodsy,

    That stove looks great, with a very strong flame!! I'd recommend you burn a couple of tanks full of Coleman fuel before deciding to do anything else. Looks to me is if you stove is burning out any residue that still remains. Also, put a pot of water on it and I'll bet the yellow tips on you flame disappear. Your Svea us now running very well, indeed, and hearty congrats for sticking to your fettling!! Well done, and thanks, very much, for all great photos. Have fun, and God Bless

    Every Good Wish,
    Doc
     
  6. woodsy97845

    Offline
    Joined:
    Jul 13, 2012
    Messages:
    105
    Thank you, Doc.

    I am happy with it. I am pretty sure that the old kerosene has been cleaned out. I rinsed the tank out with fresh Coleman gas and replaced the wick. I will continue with it just the way it is. I boiled a pot of water earlier, and it did a great job. I plan on making coffee with it in the morning. It is going hiking with me next week.

    Cheers,

    Woodsy