I prepared this stove I washed all the parts When it is blown into the tank from the air hole by the air mouth, the oil rises up from the Ziggler But no matter what I pump, it is useless Please advise how to repair the pump, thank you
The piston of the pump is healthy and the leather of the pump is also good. The end of the pump is blocked
Spray some WD40 or similar release fluid down the pump tube and leave it to soak overnight. Replace the pump and try pumping it up. Get some air pressure under the pump and give it a good hard rap with the palm of your hand. I have released a few like this.
Be careful that you do not break the solder joint of the pump tube. These are old stoves, not firewood.
Agreed. If you cannot get Kano Kroil.... Mix acetone and ATF (Automatic Transmission Fluid) 50/50 (equal parts) Penetrating oil soaks into tight/hardened spots and helps lubricate and makes removal easier. WD40 displaces water.
snwcmpr،The Warrior؛clancambo Hello friends, thank you I used a type of acid that was used to open the hole in the radiator of the heating package The way for air to enter and oil to exit was opened The acid caused the pump to be repaired, but it spreads out from the valve and valve of the oil In short, we had fun with Primus for a few hours, thank you pump
Hello, dear friend, I have a question. What is the maximum allowed amount of oil that can be poured into the Primus tank? I poured oil in this oven up to the top of the pump, but the fuel did not return. Should the amount of oil be up to the top of the pump or not? Thanks for the advice I mean, if I pour a little oil, the fuel will not return