I agree with Ron. I'd keep the 400. I have a special reason for that: I can rebuild the 400 or 400A's generators. The vaporising tube is very...
Do the prickier wire opens fully the jet? If you have forgotten to attach it to the valve core or is longer than required, the jet may be partly...
John, I kindly suggest to use viton o-rings whenever possible, especially if it is in direct contact with gasoline or oils. Nitrile or NBR o-rings...
Since I have both Coleman and BR12 stoves I can cite the differences: 1. BRS's air pump's orifice is at the bottom. When pumping you can hear...
Yes, if you can find correct music instrument's wire, it will do the job. A guitar or similar instrument's wire will fit. Sesrch for 0.2mm or...
I always fill my stoves on a flat surface. From now on, I'll fill them on a kitchen scale to be sure not to overfill. The signs of overfilling...
Hi, After heavily using my Coleman 400A and 533 stoves, I've finally understood the bleeding jet issue. I was occasionally experiencing a red...
I have same stove too. I have used up many tanks of gasoline, the soot accumulation was not that much. I wonder if there is a carbon deposit when...
My pleasure. My stove's generator has clogged today. After many left-right rotations of the tip lever, the jet finally opened and my stove started...
After heavily using my stove with gasoline only, I have finally encountered the famous clogging issue. My stove has started with yellow flames and...
Hi, If you own a Coleman 400A stove or single burners that have two control valves and have encountered a generator clogging issue, do not...
Yes, in "Reborn 400A stove" topic in this forum or CCF "Collections: Restored Pieces and Before & After Projects" I explain in more detail the...
[ATTACH] This is my final cleaning tip lever
This is my evolution of fabricating generators
[ATTACH]
You can adjust the distances with a flat screw driver when needed. You will insert it where the gap is small then by turning the screw driwer you...
This is what is inside my generator tube [ATTACH]
The generator tube is a copper tube with a 5mm of diameter. Brass tubes are harder to work on it. My generator tube is a tube made of plain...
I have had explained this earlier in more detail in CCF's Collections: "Restored Pieces and Before & After Projects" part. The topic name is "Re...
@Tony Press Plain copper tube has performed very well. I was afraid of the oxydation too like cheap solderin iron's tip however due to excessive...
Separate names with a comma.
