Hi everyone, I know this has been asked before but has anyone got or could take a decent photo of the decal on an Enders 9060D. Doesn’t have to be perfect. I can find two (photo’s) but neither are correct. Mine is this one.
2 days in electrolysis tank, jet, needle etc cleaned in ultrasonic, new SRV & NRV pips made to replace hard ones. Case resprayed. Just need decal for lid.
Hi Pharael, that’s one of the two I found. The other was a 9060. I’ve printed it onto clear water slide paper ready! I’ll hold out for a little while and then I’ll make the decision to use that one or just leave it blank. Someone somewhere must have the same one. I know the question was asked on the fettling forum with no luck. Thanks for the reply, all the best. Dave
