Enders 9061 pump assembly

Hey

I need the help of the experts.

I picked up an enders 9061 today. At first the pump did not buIl pressure. The leather was dry. So I removed the NRV and poured a bit of oil into the pump tube. I was able to build pressure to get the stove to fire. However the pump is not sealing with each stroke. Now in fairness I am impatient by nature so didn’t fill the tube completely and leave it to soak for days. Would it be best to try this approach over trying to disassemble the pump tube (which I cannot figure out)

cheers

john

 

@lamafat

The following 2010 post from @presscall of his 9061D will hopefully be of help to you.

Enders 9061D

Pharael.

 

You probably need seals and rings....

 

Any suggestions on where to get some none on ebay

 

Check our sponsor, thefettlebox.
Duane

 

If you PM @sefaudi, he will be able to assist you.

Pharael.

 

Hello!
Since I'm completely new here, I would like to ask for your help on how I can write a private message to Sefaudi? I need Pumpa leather and I know that he has very good quality products. Thank you! Zoltán

 

maybe this, if Sefaudi would be not contacted:

Enders-Rundumsorglospaket - Full-Enders-Repairkit

RJ

 

Hi! Thank you for your answer! However, it is probably due to a translation error, I don't know what you mean. Can I order a complete gasket set from the link you provided? Do you sell these? Regards: Zoltán

 

hello Zoltan,
yes you can order the set at me, send me a PM.

Markus