Thanks Jeff, much appreciated. Scott
I've got someone that needs a tank lid seal for a 121. I am not very familiar with the stove and have not seen one before. I think the lid seal...
I've purchased quite a few on eBay, including (2) Sievert model 123's - one for $58 and one for $68. I've won regular 123's for as low as $25 and...
Yes, heard of it. Ultra Low Sulfur Kerosene is just No. 1 diesel with no more than 15 ppm sulfur. Scott
There's still plenty of K1 right at the gas station pumps here in Northern New York, $3 or so a gallon. The photo below is using K1, un-dyed, at...
Mine from SG was actually quite nice, Although I had some problems with the cleaning needle and the cap had a small deformity that was preventing...
I seem to get better simmering capability with Coleman fuel (no yellow flame at all) as compared to Kero. Anything above a low simmer, though...
Thanks for the help. This is my first 111 triple fuel and I'm amazed at how fantastic these are when running properly. I'll try some kero in it...
I finally got the 111 running perfect with a new burner cap. My only question now is how to actually attach the cap. The original had two tabs...
Haven't yet been able to get a satisfactory flame pattern out the 111. Still far too much yellow flame with Coleman fuel, and kero is not...
I tried a couple of different jets that I had laying around. All were from older stoves so I was unsure of their actual condition, but I finally...
I do have what I would consider too much yellow flame and I'm not satisfied with that. I think I have an extra 111B nozzle that I can fit on...
Sportsmansguide.com had what was an apparently very limited quantity of 'surplus' 111's. Luckily I spotted the ad quickly and picked up one for...
Just yesterday I replaced the pip in one of my caps. If you have a bench grinder it's fairly easy to grind down an allen wrench to five sides and...
Yes, I was not aware of another one. The tank cap has an elongated brass tube containing the "NRV". This tube contains a spring and a small...
I'm looking for replacement pips for the stem of some pump caps, not the pips inside the top of the cap. If anyone has some extras I'm willing to...
What I have done in the past is take out the jet and the regulating spindle/packing/etc. and just spray it right through with something like WD40...
A tooth brush and some Brasso gets the hard to reach areas, I have a 6" unwoven nylon aluminum oxide flap wheel that works great on everything...
I've been trying to buy one of these old Sievert models for a while now and the other day I actually bought 2 for about half of what I'd seen them...
I don't have any nalgene bottles so I wouldn't know. The GSI cup fits the 123 with the same 'snugness' as the original cup does. It does not...
Separate names with a comma.
