last 2 line need correcting--- Mjet-k/Colmans=0.32mm(.013") #2502 Mjet-alcohol=0.32mm(.013")+air restrictor #2502/#2509 I'm bad.
In general,dependent on air mix system, Range of Jet Sizes Used for Optimus 206/207B burner ±.02mm(.0008") wo/noticable change Ajet Alcohol...
No, You don't seem to be missing any parts. But by your 5th photo it seems that the air regulator inside the cap may be rusted closed. that...
Retro Camper when you say you've got the right jet and restrictor, I'm not sure what you mean. If you're using the "A" jet[Alcohol 0.51mm(.020")...
First of all welcome to the forum. OK, the difference between the 400A and the 400B is only the flame control lever (black). The 400B is still...
It's to keep the sprits from leaking past the threads into the pan. I've used small lead washers to good effect. One problem I've seen is that...
Kero will last for years, as long as it's in a sealed metal container. Plastic will leach the volitals in both Colmans & kerosene, after about a...
Find 207b regulated burners(Stuga-Cabana)& heat proof washers from Kerophile, change out, done. Do not discard your 209a alcohol burners, some...
1915 is the part number. These burners will burn almost any fuel depending on nipple(jet)size. .011"-.013" kero, .013"-.015" Colmans, or .020"...
The .37mm jet is slightly smaller than ideal but should work just fine(air rich). I find it strange the wife likes the more dangerous fuel the...
Ok, how to put this without ruffling to many feathers. If you use the proper jet(nipple) for the fuel, NO restrictor is needed. That is an "A"...
Removing the burner bell from the vaporizer. Heat the burner bell at the coller only, then quench the vaporizer only. Usually falls off If not,...
Never heard of one surging without heat so I'd be guessing. My first thought would be water moisture in the wick. I know you said wick is fine,...
In your picture, It appears that the emboss in the bottom of the case has been somewhat flattened. If thas the case, than double-d'ing the...
oop's
In Doc Mark's post above, #226056, he show a exploded view of a burner assembly for a 9122 stove. The extender threads to the bottom of the valve...
Mike the threaded part you seem to be concerned about , is called a burner extention. It is correct. what wrong is the spirit cup, yours is for...
Yes, It should be hotter, but there are a couple reasons for that. Colmans fuel 129,650 btu's per gal/US. Kerosene 134,950 btu's per gal/US. So...
Hi again; You mention 2 unrelated problems, pulsing flame and noise. The pulsing flame is caused by local sudden pressure increase inside the...
First off, Welcome to CCS. I had one of those. As the factory in Sants-fe Springs was only 50 miles from Newport Beach, I bought local. To my...
Separate names with a comma.
