Are you sure it's not vertigres? In the presence salt air. it can remain almost runny like. It also forms from the cloride in salt. Columbia...
As the turn signal is not on top of the fender, it's a pre '57. And with such a short beach, I'd guess southern England, grass is growing to...
It's totaly dependent on the burners supplied with that stove. If you have the 4 tube regulated burners, then it is just a matter of jet change &...
Simple question, not simple answer. The threads on thr 2pt. burner are 100 yrs. obsolete. 37/64-34. Nobody will cut 34 threads per inch...
The washers have to be high heat resistant. auto part stores have exhast gasket materal to punch washers from.
Port Hadlock-never been that far south on the sound. What make boat do you have? Propane is for convience. It is easier to lite. But it is not...
If You absolutly need a burner, Stuga-Cabanana has 2-pt burners & blanking plugs. Base camp should have blanking plugs. That said, I can hardly...
stainless steel .030 thick, found at marine stores for locking the anchor shackle to the chain.
a capfull of acohol in the tank, if your going to burn empty will remove most of the water from the wick. Water destroys wicking ablity.
If the fuel is old, could be bad. I've seen some really bad colmans still burn, but not well.
Range of Jet Sizes Used for Optimus 206/207B burner ±.02mm(.0008") wo/noticable change Alcohol 0.51mm(.020")/no air restrictor #2508 isopropane...
natural gas jets are larger diameter thn LPG jets. If you have small flame, it's not NG.
Your "restrictor" looks like the clip from a lighter. Petrole on the box refers to the 111B. A true 111/7 has a .028" jet for kerosene only. A...
10 Kero burners & 1ea 2-burner gassy. All 95+ percent.
I'm sorry leather will not hold the pressure. It's not what holds the pressure in a lamp. The non-return valve(nrv) does. The flame shot shows a...
the coleman pump has to much volume. the fitting is different for connecting to tank. So no not w/o modiftcation.
That brings up the question of what wire is preferred for securing burner caps?
Might even be enough metal mass to varporize kero. Need a way to prime though. also jet will be to large.
Yes they do burn very nice with colmans gas. But it is so very much more dangerous. Be very careful. And you can use colmans for priming like a...
leaving the spindle out is prefered. but be careful where it is pointing, (two exits).
Separate names with a comma.
