Enjoy this beauty. Well done
Beautiful outcome and an efficient work.
Thank you
I was offered today to purchase the machine shown in the attached images. Seems for an Italian company that was dissolved into another. I usually...
I focused the torch on the nut in fact, the burner was deemed defective already, and I will try to salvage it later if possible. I installed the...
Thank you, @hikerduane. Actually, there was no solder; it was just very tight with some dry material. I reduced the amount of water in the tank,...
The burner is quite worn out. It has several deformities and vulnerable areas. I have a similar spare. I will try to repair it in the future if...
Needed indeed.
Thank you everyone for the valuable contribution, will keep trying. Thank you @kerophile for the important link.
Thank you @Blackdog. The lower one is also quite stubborn. I will try with a vise. Regarding the rotational direction, does it rotate in the...
Like a hopeless case. I tried with full power, nothing moving but splinters of brass. Will focusing the torch on the lower nut melt the connection...
I attempted that @Dean and discovered it to be quite resistant too. I'm uncertain about how much I can increase the tuning power on these before...
Hello everyone, I am trying to detach the burner from my Optimus no. 00 that I inherited from my father-in-law. The burner is fimly stuck. I have...
Great work. Burning nice
Yes @Yannick Michel , I've mentioned that in my first post above. I am experimenting in fact, nothing to be considered a major conversion for such...
Used the cap this morning to effectively accommodate the PT-1 Tourisy (8r clone). Observe that despite a slight accidental tilt of the cap, the...
After a bit of filing work, contact is now better with the lipstick. All went well.
Accomplished some work today. Cleaned the pump, quickly fixed the NRV (initially attempted to replace it) and found that the spare parts I have,...
Great progress there.
Attempted to install a complete bell today. It functioned properly for 15 seconds, then failed due to inadequate heat transfer. I will try again...
Separate names with a comma.
