Remove spindle from tank SVEA 123R?

Discussion in 'Fettling Forum' started by Gigi Galbreath, Jul 24, 2020.

Page 3 of 3
  1. ROBBO55

    ROBBO55 Subscriber

    Offline
    Joined:
    Oct 27, 2014
    Messages:
    2,698
    Location:
    Somersby, New South Wales, Australia
    ROBBO55, Jul 31, 2020
    #41
  2. Tony Press

    Tony Press Australia Subscriber

    Offline
    Joined:
    Jun 8, 2013
    Messages:
    10,858
    Location:
    Stinkpot Bay, Howden, Tasmania, Australia
    Excellent!

    Cheers

    Tony
     
    Tony Press, Jul 31, 2020
    #42
  3. Harder D. Soerensen

    Harder D. Soerensen United States Subscriber

    Offline
    Joined:
    Oct 24, 2017
    Messages:
    2,156
    Location:
    Denmark
    Harder D. Soerensen, Aug 1, 2020
    #43
  4. kerophile

    kerophile United Kingdom SotM Winner Subscriber

    Offline
    Joined:
    Sep 23, 2004
    Messages:
    14,341
    Location:
    Far North of Scotland
    Hi @Gigi Galbreath . Great News. If CCS handed out medals I would nominate you for one (Tenacity and Perseverance).
    Well Done,
    Best Regards,
    Kerophile.
     
    kerophile, Aug 1, 2020
    #44
  5. kerophile

    kerophile United Kingdom SotM Winner Subscriber

    Offline
    Joined:
    Sep 23, 2004
    Messages:
    14,341
    Location:
    Far North of Scotland
    Hi @Gigi Galbreath Please do not run the stove with the control key in place or you will get “Branded” by the metal when you next touch it.
    Best Regards,
    Kerophile.
     
    kerophile, Aug 1, 2020
    #45

  6. Pinnah

    Offline
    Joined:
    Jul 7, 2016
    Messages:
    23
    Well done on the rebuild.

    My 123R will candle a bit if I shut it off by turning it off. I'm sure the tip of the spindle is worn.

    But, I generally extinguish the stove by turning it fully OPEN, so that the cleaning needle is fully up. This shuts down the stove entirely without resorting to any pressure.

    AFTER the flame is out, I close the stove slowly so that pressurized gas can blow through the jet. I then park the valve in the fully closed position with minimal pressure.
     
    Pinnah, Aug 5, 2020
    #46
Page 3 of 3