Discussion in 'Fettling Forum' started by DougR, Sep 13, 2006.
Calculated Stove powers:
Reserve caps for No.96 and No.100 stove types
"Reserve caps" or transport screws which rely on the lead seal are never very satisfactory, and will almost certainly leak if you pressurise or even tilt the tank.
This is because reserve caps are seldom fitted with hexagonal tops so you cannot tighten them down on the lead seal as much as you can a burner assembly.
For transit of No.96 and No.100 stoves, which also rely on a lead seal, I have used an additional temporary washer of Viton or good quality Nitrile rubber. I place this on top of the lead seal before positioning and tightening the reserve cap.
Of course you must remember to remove this temporary washer before using the burner assembly.
I use circular rather than ring washers for the purpose. These washers are about 1.6mm ( 1/16 in.) thick.
Tank Dent Pulling
Hi, this thread includes some photos of a nice technique for dent-pulling on a classic stove tank:
Thanks Arachnocampa and gunsoo
Hi, this is a neat approach to an old problem: How can you reduce or remove dents from the tanks of classic stoves and Lamps?
Dent Removal and tank repair:
Hi, I thought it would be useful to post this link here :
When were one- piece rubber NRV "pips" introduced?
Lead-tin soldering links:
Adding stove legs to Op.80 and Pr.70/71 stoves:
IMPROVISED PAN RINGS/ TRIVETS FOR CLASSIC STOVES.
Bicycle clips or clamps for stoves/ Terry Clips.
Stop showing off George....
Separate names with a comma.